trolling and finding: diy macrame
my love for macrame includes one day learning how to do it.
+ Waxed cord—you can also use hemp, yarn, suede cording, or any type of string, really.
+ A flat surface—a board, piece of cardboard, or a wall all work.
+ 4 push pins or nails
Instructions for a macrame friendship bracelet:
Step 1: Cut one piece of cord at 1 ½ yards long and another 2 ½ yards long. Fold the two strands in half and pin them into the wood, cardboard, or wall at their middle. The two longer strands will be doing the knotting, so make sure they are on the outside and the short strands are on the inside. Pin the inside strands in place.
Step 2: To make a square knot, first create a loop with the left outside strand, tucking it under the two middle strands and over the right outside strand. Create a loop with the right outside strand, this time crossing over the two middle strands and tucking under the left outside strand.
Step 3: Reverse the process, crossing the left strand over the middle and under the right one and the right strand under the middle and over the left. Pull both outside strands up and out until you create a knot on the two strands in the middle.
Step 4: Repeat step 2 and 3 until you have created a series on knots—under and over, over and under, then pull. You can continue with this knot to make a full bracelet (jump to step 9 to finish), or you can move on to step 5 to learn a half knot, which looks like a twist.
Step 5: For the half knot, the string in your left hand will always go under then over, and the strand in your right hand will always go over then under.
Step 6: Pull and repeat 5 until you have about 2 inches of loose string at the bottom of the bracelet, and tie the ends into a knot.
Step 7: Take the bracelet off the board and pull the end knot through the loop at the top. Ta-da! You have a macramé friendship bracelet.